Over time, garage door repair hinges can loosen, and the rollers that run in the tracks can develop cracks. Replacing these parts can quiet your noisy garage door.

What to do if your garage door is broken?

In addition to tightening the bolts that connect the hinges to the frame, you can also lubricate them. A commercial lubricant designed for garage doors works best. It goes on liquid and dries to a non-tacky grease that won’t attract dirt.

The door’s springs balance it to open and close smoothly, and when they get off kilter, the opener has to work harder to move the door up and down, which can shorten the motor’s lifespan. To test the balance, disconnect the opener and manually lift the door about halfway. If it stays in place, it’s well balanced. If it continues to move upward or fall downward, call a professional.

The lifting cables that run from the torsion springs to the garage door can also become worn or rusty and need to be replaced. These are not a DIY project, as they’re under high tension and can cause severe injury if handled incorrectly. A technician should be called in to replace the old cables and install new ones. Finally, the bottom seal can also wear out and need to be replaced. This can help keep heat inside the garage and prevent pests from crawling in through the opening at the bottom of the door. A replacement is a relatively simple job that any homeowner can do.